Are you looking to mount large signs directly to walls? If so, we have the solution! This ingenious two piece, interlocking wedge-shaped banner hanger assembly makes it safe and simple to display and change out signs of almost any size directly from walls. Each assembly consists of one wall mount track and one binder banner hanger piece - both sold separately. Simply prep the wall by screwing the wall mount track piece to the wall (mounting hardware included) and then fasten the binder banner hanger piece onto the top edge of the sign (barrel bolt and screw fastening hardware included) and gravity does the rest. Signs hang approximately 1 inch offset from wall which, when combined at the bottom of the sign with our #150675 Square Foam Blocks, creates a handsome dimensional effect. Removable and reusable - all safely from floor level. For use from ground level with our K-Stick™ Ladderless Poles. Warning: Not recommended for outdoor use. Wall mount track must be firmly attached to wall. Male and female barrel bolt fastening hardware must be fully screwed together. Patented
  • Wall mount track and binder banner hanger piece are each sold separately
  • Wall mount track has holes at 16" on center and comes with toggle screw anchors, stud screws and an instruction sheet
  • Pre-drilling of holes for wall mount track is required (drill bit sold separately)
  • Wall mount track piece is 3" tall x 1" wide
  • Custom colors and lengths available
  • White PVC material
  • * For larger, heavier signs over 5 pounds it is possible to have two or more individuals, each with a K-Stick™, raise or lower simultaneously.
Unit of Measure

Specifications

Length

N/A 48"

Assembly Type

N/A Wall Mount Track

Safe Working Load Limit*

N/A 5 lb

Material

N/A Polyvinyl Chloride (PVC)

Hanger Height

N/A 3"

Hanger Width

N/A 1"

Color

N/A White

Note

Note

N/A * For larger, heavier signs over 5 pounds it is possible to have two or more individuals, each with a K-Stick™, raise or lower simultaneously.